Transition-networks CPSMC0800-100 Manuale Utente Scaricare il pdf (Pagina 11)

CPSMC0800-100 PointSystem

™

Chassis

slide-in-modules

2.2.3 Replacing the Mangement Modules

CAUTION: Wear a grounding device and observe electrostatic discharge precau-

tions when replacing Media Converter Slide-in-Module(s). Failure to observe this

caution could result in damage to, and subsequent failure of, the Management

Module(s).

NOTE: The Managment Modules are NO

hot-swappable.

To replace a Managment Module:

1. Remove the Managment Module to be replaced by loosening the one (1) screw

that secures the Managment Module to the CPSMC0800-100 chassis front.

Slide the Management Module from the CPSMC0800-100 chassis.

2. Align the replacement Mangement Module with the installation slot so that the

panel fastener screw is at the top.

3. Carefully slide the replacement Managment Module into the installation slot.

NOTE: Ensure that the Managment Module is firmly seated against the back of

the chassis.

4. Install the replacement Managment Module by carefully rotating the attached

panel fastener screw clockwise to secure the Managment Module to the

chassis.

Tech Support: 7am-6pm CST (GMT -6:00) 1-800-260-1312 International: 00-1-952-941-7600

PWR

CPSMC-0800

8-Slot Chassis

Mpls, MN 55344

Input Power:

110-240 VAC

1.6A max. (60W max)

50/60 Hz

10BASE-T

INPORT

MCCM10

MGMT MASTER

OUTPORT

12C

12C-1TERM

INIT

LNK

PWR

RESET

DB-9

Panel Fastener Screw

1 2 ... 6 7 8 9 10 11 12 13 14 15 16 ... 25 26

Commenti su questo manuale

Nessun commento

Transition-networks CPSMC0800-100 Manuale Utente Pagina 11

Commenti su questo manuale

Prodotti e manuali riguardandi Hardware Transition-networks CPSMC0800-100